Back to FAQ

Architect_058 Architect Special Interest Group November 2014 (pm)

Architect, Public Posts, Vectorworks jonathan

Unlock your potential as an architect with our exclusive eBook on Vectorworks software


With this quickstart manual you will discover the tips, tricks, and tools you need to take your designs to the next level and impress your clients. Whether you're a seasoned pro or just starting out, this eBook is a must-read for anyone serious about their craft.

image064In this session we looking in detail at how to set up a wall style that uses Design Layers, Levels and Stories to control the elevations of the wall components and how to connect the wall components to slab components.
 

[ms-protect-content id=”34491,34492,34493, 34494, 34495, 34496, 344927″] [FMP]https://s3.amazonaws.com/vectorworkout/BIM_SIG/Architect_058_Nov14_pm.mp4[/FMP] [/ms-protect-content]

Related Posts

Comments

  1. Hi, towards the end Tony had an issue with a section of wall below the insulation. Would it be easy to create the deeper setdown in the slab and then just create a wall style and top bound -50 and bottom bound -172+50=222, to fill in the gap between the slab setdown and bottom of insulation.
    Thanks for this learnt a lot again.
    Regards

Leave a Comment