BIM_SIG_012 Special Interest Group October 2012

With the introduction of Detail Viewports in Vectorworks 2013, we are looking at how this will change the way you create your drawings. In this webinar we looked at how to create the new viewports, how they can be used, and how they might change the way you create your drawings.

Topics Covered:

• Creating a Foundation viewport
• Creating a section viewport
• Creating sheet layers
• Locating a viewport on the sheet layer
• Creating a Detail Viewport
• Creating several detail viewports
• relocating detail viewports on the sheet layer
• Re-numbering detail viewports
• Creating a worksheet to control Drawing Label numbers and titles
• Exporting the worksheet to you library
• Duplicating a detail viewport
• Hierarchal classes

[ms-protect-content id=”34491,34492,34493, 34494, 34495, 34496, 344927″]
[FMP]https://s3.amazonaws.com/vectorworkout/BIM_SIG/BIM_SIG_012.mp4[/FMP]
(due to the recording technique, you cannot hear the questions from the participants)
[/ms-protect-content]