Hardscape is a special tool that makes it easy to draw areas of paving. This…
Site Modeling – Part 13
Texture Bed – You can use this to add colors to part of the site model. This doesn’t so much edit the site model, as apply areas onto the site model.
[ms-protect-content id=”34491,34492,34493, 34494, 34495, 34496, 344927″]
[FMP]https://s3.amazonaws.com/vectorworkout/Guide_to_Productivity/movie09_13.mov[/FMP]
[/ms-protect-content]
Comments
Leave a Comment
You must be logged in to post a comment.
Jonathan
This is a comment on the entire Productivity posts – Thank you! It has been a great refresher and source of new tips. I greatly appreciate these posts.
Can you do the Modify commands ‘Compose’ and Decompose’ – when to use and when not to use.
Group and Ungroup would also be helpful.
Thanks again Jonathan!
Richard Stiers
great suggestions. I will look for a way to cover these. I haven’t even uploaded half of the productivity movies yet
When I tried to use textured beds on the site model as you indicated I was unable to edit textures. I was hoping to add more than just colours but apply textures from the VW library in order to model surface treatments or construction material applied.
Thanks,
I have tried this on Vectorworks 2013 and I have found that I am able to create textures and apply the textures to the texture beds. But in order to do this, you must set up the classes to have the texture applied. It might be a good idea to set up different classes for different areas of the texture beds.
Please see this post:
http://archoncadcom.wpengine.com/2012/10/9554/epodcast164-assigning-textures-to-texture-beds/